Installation guidelines – Waterworks .25 One Hole High Profile Bar Faucet, Metal Handle User Manual

Page 2

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST

.25
One Hole High Profile Bar Faucet with Metal Lever Handle

Installation Guidelines

Page 2 of 2

Rev - 01

10.31.2014

These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 ONE HOLE HIGH PROFILE BAR FAUCET WITH METAL LEVER HANDLE (STYLE No. PTKM30, PT30KM UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.

3. Re-install the RUBBER WASHER, METAL WASHER and

MOUNTING NUT. Securely tighten the MOUNTING NUT
to secure the SPOUT to mounting surface.

4. Connect the ADAPTERS from the HOSES to the water

supplies making sure the O-RINGS are inside the
ADAPTERS. See FIGURE – 02.

FIGURE - 02

5. Connect the HOSES to the ADAPTERS making sure

they are not pinched or kinked.

FINISH AND INSPECT THE INSTALLATION:

6. Remove the AERATOR from the SPOUT using the

TOOL provided then open the hot and cold supplies
and carefully operate the HANDLE to flush out any
debris in the supply lines.

7. Inspect all connections for leaks.

8. Shut the water off and re-install the AERATOR.

SERVICING THE PRODUCT:


Refer to FIGURE – 03 for steps 9 & 10.

9. To remove the SPOUT, loosen the SET SCREW behind

the SPOUT then pull the SPOUT up to remove.

10. To access the CARTRIDGE, loosen the SET SCREW

beneath the HANDLE, pull the HANDLE off, unthread
the GLAND COVER then unthread the RETAINING
COLLAR to expose the CARTRIDGE.



If further assistance is required, please contact Product

Support at 1-800-927-2120 Ext 2 Monday through
Friday, 8am - 6pm EST.

* Putty contains oil and can cause permanent

discoloration on certain materials such as marble,
granite and any porous surface.

O-RING

ADAPTER

O-RING

ADAPTER

FIGURE - 03

RETAINING

COLLAR

SPOUT

SET SCREW

GLAND COVER

HANDLE