Waterworks Easton Classic Wall Mounted Extension Pot Filler, Metal Cross Handle - Manual

These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON POT FILLER (EAKM21)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
Installation Guidelines
W A T E R W O R K S ®
2/06
Easton Pot Filler
1 1
2
"
5 5
8
"
10"-13 1
2
"
2 3
8
"
5 7
8
"
8 1
2
"-12"
EAKM21
IMPORTANT
To ensure this product is installed properly, you
must read and follow these guidelines.
The owner/user of this product must keep this
information for future reference.
Be sure your installation conforms to local codes.
This product must be installed by a professional
contractor.
Inspect this product to assure you have all parts
required for proper installation.
Use only a strap wrench or protected/smooth-jaw
wrench on any finished surface
ROUGH IN:
1. Determine the ideal location of the faucet body
based on the clients preference.
2. Finish the rough in by installing a well supported 1/2"
NPT nipple. The face of the nipple should be
recessed ¼" behind the surface of the finished wall.
INSTALLATION:
3. Loosen the 2mm set screw (4) on the underside of
the valve body (3).
4. Pull the brass adapter (6b) out of the valve body then
using a 12mm hex wrench, thread the adapter onto
the NPT nipple.
5. Slide the escutcheon assembly (7-7b) back onto the
valve body, thread the faucet assembly onto the
adapter (6b) then tighten the set screw. Slide the
escutcheon toward the wall.
6. Remove the spout by unthreading the spout nut (5b)
then turn on the water to verify proper function.
7. Note that a primary filter screen is located inside the
spout nut (5b). A secondary filter screen is located
inside of the spout collar (5). To access the
secondary filter screen, unthread the spout collar and
pull off the front portion of the spout.
8. Remove filter screens and flush throughly.
9. To adjust the spout reach, simply pull/push the spout.
The spout reach can be locked at a fixed position by
tightening the spout collar (5).
10. To access the cartridge, unthread the handle
assembly (1-1h). Do not over-tighten the handle
assembly; hand tight is adequate. If this assembly is
too tight, the handle will bind.
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).