Waterworks Formwork One Hole Low Profile Kitchen Faucet, Metal Joystick Handle and Spray - Manual (Page 2)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Single Hole Kitchen Mixer with Spray
INSTALLATION GUIDELINES
Page 2 of 2 7.18.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK SINGLE HOLE KITCHEN FAUCET WITH SPRAY
STYLE NOS. FMKM10 & FM10KM (UK)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
INSPECT THE INSTALLATION:
11. Remove the flow restricting AERATOR using the
tool provided, then carefully open the hot and cold
valves to flush out any debris in the supply lines. See
Figure 1.
12. Inspect all connections for leaks.
13. Re-install the flow restricting aerator.
SERVICE THE CARTRIDGE:
¾ See Figure 4 for steps 14 & 15.
14. Remove the SET SCREW from the back of the
joystick HANDLE. Unthread the COVER, and lift
handle to remove COVER, PLASTIC WASHER &
HANDLE.
15. Unthread RETAINING COLLAR to remove
CARTRIDGE from SPOUT ASSEMBLY.
SET
SCREW
SPOUT
ASSEMBLY
CARTRIDGE
RETAINING
COLLAR
COVER
HANDLE
ASSEMBLY
SET
SCREW
SPOUT
ASSEMBLY
CARTRIDGE
RETAINING
COLLAR
COVER
HANDLE
ASSEMBLY
FIGURE - 04
¾ If further assistance is required, please contact
Product Support at 1-800-927-2120 (8am-6pm EST).
¾ See service part document for parts ordering,
available on WATERWORKS.COM.
* Putty contains oils and can cause permanent
discoloration on certain materials such as marble,
granite and any porous surface.
† BSP Adapter can be ordered separately:
(2x)
STYLE No. UNUK08
ITEM No. 45-23699-89112
OUTLET
HOSE
3/8" PORT
DIVERTER
ASSEMBLY
1/2" PORT
RETURN
HOSE
OUTLET TO
SPRAY
CHECK
VALVE
HOUSING
OUTLET
HOSE
3/8" PORT
DIVERTER
ASSEMBLY
1/2" PORT
RETURN
HOSE
OUTLET TO
SPRAY
CHECK
VALVE
HOUSING
FIGURE - 02
SIDE SPRAY INSTALLATION:
CHECK
VALVE
HOUSING
METAL
WASHER
NUT
RUBBER
WASHER
HANDSHOWER
HOSE
THREADED
SHANK
O-RING
ESCUTCHEON
SIDE
SPRAY
CHECK
VALVE
HOUSING
METAL
WASHER
NUT
RUBBER
WASHER
HANDSHOWER
HOSE
THREADED
SHANK
O-RING
ESCUTCHEON
SIDE
SPRAY
FIGURE - 03
¾ See Figure 3. for Steps 6-10.
6. Remove the NUT, METAL WASHER & RUBBER
WASHER from bottom of THREADED SHANK
7. Insert the ESCUTCHEON with THREADED SHANK
into the hole in the deck, making sure the O-RING is
underneath.
8. Reattach the RUBBER WASHER, METAL WASHER,
& NUT to the THREADED SHANK.
9. Connect the conical end of the HANDSHOWER
HOSE to the SIDE SPRAY. Pass the knurled end of
the HANDSHOWER hose through the ESCUTCHEON
and underneath the deck.
10. Connect the knurled end of the HANDSHOWER
HOSE to the CHECK VALVE HOUSING.