Waterworks Easton Vintage Spray with Oak Lever Handles - Manual (Page 2)

Easton ® Kitchen Rinse
December, 1999
9/04 W A T E R W O R K S ®
These guidelines have been prepared for the professional contractor to aid in the installation of:
EASTON
® KITCHEN RINSE(Classic-EAKM07-10)
(Vintage-EAKM17-20)
All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.
Installation Guidelines
2
13. Thread the knurled end(25a) of the hose onto the side
valve(20) and the conical end(25b) of the hose onto the
rinse(26) while making sure a
1 /
2
" washer(24) is used at both
connections.
14. Connect the side valve to the water supply(not supplied).
RINSE OPERATION AND INSTALLATION
INSPECTION:
15. IMPORTANT:The side valve MUST be in the OFF position
when the rinse is not being used. If the side valve is left on,
standing water pressure will cause the rinse hose to burst.
16. Unthread the rinse from the hose and then open the side valve
to flush out any debris in the supply lines.
17. Reattach the rinse, press the thumb lever to start the flow of
water, release it to stop the water. If water continues to drip
out of the face of the rinse after releasing the thumb lever,
unthread the knurled ring from the rinse head and adjust the
slotted screw inside of the head.
18. A combination flow restrictor and check valve(21) is located in
the side valve(20) and can be serviced by removing the rinse
hose from the side valve.
19. Inspect all connections for leaks.
20. When finished, turn the side valve off.
➢ If further assistance is required, please contact Product Support
at 1-800-927-2120 (8am-7pm EST).