Waterworks .25 High Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles - Manual (Page 2)

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc.
.25 Bridge Lavatory Faucet
These guidelines have been prepared for the professional contractor to aid in the installation of:
.25 BRIDGE LAVATORY FAUCET WITH CROSS HANDLES (PTLS03-K) & LEVER
HANDLES (PTLS04-K) All dimensions are based on origin specification and are subject to change and
variation. Please consult your Design Associate for current specifications.
14. Re-attach the lower drain assembly (22) using the gasket
(20) provided then tighten until fully secured. A clear
adhesive silicone may be used to ensure a water-tight seal
between the gasket and lavatory.
15. Attach the tail piece (25) using the tail piece washer (23)
provided.
16. Connect the side valves to the water supply valves (not
supplied).
INSPECT THE INSTALLATION
17. Remove the flow restrictor assembly (15) from the spout
using the tool provided (16). Carefully open the hot and
cold valves to flush out any debris in the supply lines.
18. Inspect all connections for leaks. Reinstall the flow
restrictor assembly.
19. Push down on the drain stopper (17) to close the drain
then fill the sink with water to make sure the stopper
operates and seals properly.
20.Push down on the stopper to open the drain. If the
stopper has to be removed, simply unthread it by turning
the stopper counter clockwise.
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST)
04.27.07