Rice Lake TransAct 2.0 - Manual (Page 28)

27
Admin
Note: The Category name to which the rates are attached appears as the rate
heading. Examples in this section use the Category name Refuse 1.
During a weigh transaction, all Category items are available. If you select
a Category item with a special Rate, TransAct uses the special rate to
calculate the total charge. TransAct uses rates from the Measured Rates
table to calculate the total charge for those category items without a special
rate attached.
Click inside the Category box. Use the single down arrow next to the
Category box to select a category from the drop-down list. Once you select
a category item, click inside the first Rate box to enter a special rate. When
you leave a special rate at zero, TransAct uses the rates from the Measured
Rates table to calculate the total charge (see Section 9.4).
Use the Amount Limit box to enter the limit the item should not exceed for
the job. If the transaction exceeds the Amount Limit, TransAct displays a
warning during the transaction but does not stop the transaction.
The Total Amount box displays the total amount of the item used for the job.
Use the Charge Limit box to enter a dollar amount the category item should
not exceed for the job. Again, if the transaction exceeds the Charge Limit,
TransAct displays a warning but does not stop the transaction.
Table window to setup special Rates and Limits for these Category items.