Rice Lake TransAct 1.0 - Manual (Page 17)

1 3
Installation
Installing TransAct for Windows
TransAct for Windows requires the following hardware and software:
• An IBM-compatible computer, 486-75 MHz or higher CPU
• At least 8 MB of RAM (16 MB RAM is highly recommended)
• A fixed hard disk with a minimum of 4 MB of available disk
space to install the program files
• VGA, SVGA, or higher resolution monitor
• DOS version 5.0 or higher
• Windows Version 3.1 or later running in enhanced mode
When installed, the Setup program installs all of the files to run
TransAct, initialization files, and all icons associated with the program.
These instructions explain how to install TransAct on an individual
workstation using Windows 3.1 or Windows 95. Before the Setup
program can be run, Windows 3.1 or higher must currently be running
on the system. It is important to be familiar with the basic navigation
techniques of using Windows. If you are not familiar with moving
around in Windows, review Getting Started Using Windows beginning
on page 3 of this manual.
NOTE! Before beginning the installation, log off any networks your
computer may be a connected to, and quit any open programs.
Windows 3.1 Installation
Insert the TransAct diskette labeled Disk: 1 of 2 in drive A or B.
Choose File | Run from the Program Manager menu.
Starting Installation from Program Manager