Rice Lake TransAct 1.0 - Manual (Page 132)

128 Appendix
All of the other information in the [Weigh Options] section can be
changed by selecting the Options button in the Weigh form while
running the TransAct program. TransAct recommends using the
Options window for all other changes.
[Tares] Editing
Use the [Tares] section to activate up to three tare options. At the time
of installation, some or all of the tares were activated. Active tares are
displayed in TransAct under Admin | Customer Accounting.
To activate a tare button, position the cursor after the equal sign and
type the name for the button, remember to type the name in exactly as
you would like to see it displayed in TransAct.
Existing Name: Tare3=
New Name: Tare3=Pup Trailer
To deactivate a tare, position the cursor after the existing name and
press the Backspace key on the keyboard until nothing is displayed
after the = sign.
Existing Name: Tare2=Container
New Name: Tare2=
To change the name of a tare button, delete the existing name and enter
your desired name.
Existing Name: Tare1=Truck
New Name: Tare1=Vehicle
NOTE: For those of you familiar working with .ini files,
Tare4=Tarename will not work. TransAct only recognizes three tare
options.
[Rates] Editing
Use the [Rates] section to change the category to which Measured
Rates and Minimum Charges are attached. Enter the category number
corresponding to the category after the equal sign.
[Rates]
Measured Rates= 4
Minimum Charges= 4