Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 28)

24 LaserLight Installation and Operation Manual
4.2 Temperature
If the temperature option (PN 43412) is added after initial installation, see Section 2.0 for enclosure disassembly
instructions.
To install the this option,
1. Remove the plug from the option hole and insert the temperature probe.
2. Attach temperature probe wiring to J4 on the CPU board.
4.3 Visor Installation
An optional visor can be installed on the LaserLight 7-segment remote display and the 8- or 12-character matrix
display. Figure 4-2 shows the remote display with the optional visor installed.
Figure 4-2. LaserLight Remote Display w/ Optional Visor Installed (7-Segment Display)
Set the visor (PN 75854 - 4" model & the 8-character matrix display) or (PN 75855 - 6" model & the 12-character
matrix display) on top of the remote display and attach the visor using screws and plastic washers provided.
4.4 Pole Mount Kit
The LaserLight remote display can easily be mounted on a pole or steel I-beam using the optional pole mounting
kit (PN 75856 - 4"), (PN 77775 - 6"), (PN 85343 - 8-character), (PN 85344 - 12-character). Use the following steps
to install the pole mount option.
1. Use the enclosed 3/8" cap screws, washers and lock nuts from the parts kit to attach the clinching pole
brackets to the pole mounting weldment.
The 6" LaserLight remote display uses four brackets (PN 76999) and the 4", 8- & 12-character display uses
two.
2. Use the enclosed 3/8-16NC bolt (PN 14747), to attach the clinching pole brackets together using washers
and lock nuts. Tighten as necessary.
3. Align the back of the LaserLight remote display to the pole mount weldment so that the holes line up.
4. Use enclosed 1/4" cap screws, washers and nuts to attach the remote display to the mounting weldment.
Reference
Number Model Description Figure
4" 6"
See Figure 4-3
25
2 77000 76998 Weldment, Pole Mounting (1)
8 14635 Nut, lock 1/4-20NC HEX (4)
3 14747 Bolt, 3/8-16NCx2-3/4 HEX (4" model - 1) (6" model - 2)
10 14955 Screw, cap 1/4-20NCx1/2 (4)
7 15019 Screw, cap 3/8-16NCx1 HEX (4" model - 2) (6" model - 4)
9 15145 Washer, plain 3/8 type A (8)
4 21938 Washer, plain type A (4" model - 4) (6" model - 8)
5 22072 Nut, lock 3/8-16NC HEX (4" model - 3) (6" model - 6)
6 76999 Bracket, clinching pole (4" model -2) (6" model - 4)
11 77001 Screw, mach 3/8-16NC (4" model - 3) (6" model - 6)
Table 4-1. Parts Kit Contents (4" and 6" Models)
Note