Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 21)

Configuration 17
3.4 Testing the Remote Display
The LaserLight remote display provides a test to check the hardware of the remote display. These tests can be
accessed through the main menu (Figure 3-7).
Figure 3-7. Test Menu Choices
Serial Menu
Port 1 Parameter Choices Description
Level 3 submenus
BAUD 1200
2400
4800
9600
19200 Baud rate. Selects the transmission speed for Port 1
PARITY ODD
EVEN
NONE Selects the parity of data transmitted from Port 1
DATA BITS 7
8 Selects the number of data bits transmitted from Port 1
STOP BITS 1
2 Selects the number of stop bits transmitted from Port 1
ECHO ON
OFF Enable this feature to allow echoing between the remote display and other
devices. If enabled and echoing, the baud settings must be set equal to or
greater than the device being echoed to.
LOCK OFF
ON If this parameter is disabled, the echo port display uses the same
communications settings as the indicator port after an Auto-Learn is run.
Table 3-6. Port 1 Serial Menu Parameters
CONFIG SERIAL TEST VER
DISPLY LOOP BK DIGOUT DIGIN
LL-OFF LH-grn arrow HL-grn circle HH-red circle
XX