Rice Lake SURVIVOR LaserLight Series Stop/Go Remote Displays - Installation & Operation Manual - Manual (Page 15)

Configuration 11
The setup button is located on the secondary display board (Figure 3-2).
Figure 3-2. Setup Button Location on Secondary Display Board (7-Segment Display)
The display board is mounted on a hinged mounting plate to allow for easy access to the CPU board. Press the
SETUP button (shown in Figure 3-2) to access main menu configuration parameters.
Main menu parameters include:
• Configuration
• Serial communications
• Test
• Version
The LaserLight remote display can be configured and displayed using a series of menus accessed using internal
buttons located on the secondary display and shown in Figure 3-3.
Figure 3-3. Configuration Setup Buttons
Use the UP/DOWN, LEFT/RIGHT buttons to navigate through menu items and the ENTER button for setting a
selection.
Figure 3-4. LaserLight Main Menu Options
Jumper position
for decimal point
or comma
Setup button
DOWN
RIGHT LEFT
UP
SETUP
ENTER
TEST SERIAL CONFIG VER