Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 49)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 43
40) 【Print start/Print finish setting】《GS G n》
Code：〔1D〕h＋〔47〕h＋n
Operate on printer status bit 7(print start/end set status).
* By using this command before and after printing data, the printer will monitor the
printer status bit 7 and will be able to detect the printer status whether it is now printing,
or finished printing.
* n has the following meaning;
n(hex) Function
21 Priner status bit 7 "1"(print start setting)
20 Printer status bit 7 "0"(print finish setting)
31
+ job ID(4Byte)
Printer status bit 7 "1"(print start setting) nomination
30 Printer status bit 7 "0"(print finish setting) , will transmit”Print
finished” message of the following format.※designated under
jobID(4Byte):n=11h.
〔 FF〕h＋〔13〕h＋jobID(4Byte)＋finished status(1Byte)
+backup(3Byte)
* The method of printing is storage type.
* Once the receiving data storaged on memory, it starts printing data storaged after
receipt of “print finish setting”.
* A little bit time-lag remains between “Reception start”and“Print start”but Printing is
stable at the highest speed. In case over printing capacity of 160mm on printing length,
Memory storages every 160mm on printing length and prints.
Therefore, the squences is repeated, on the edge between storage and printing
remains pause and start printing.
* When the data between “Print start” and “Finishing setting” happen an error on the way
of printing, you should disregard it until “Finish setting”.
* When this command repeatedly is used on USB interface, you should use ｎ＝〔31〕
h,〔30〕h only and certainly transmit next print start command after reception of finish
status.
41) 【Selection of printing position of HRI character】《GS H n》
Code：〔1D〕h＋〔48〕h＋n ※〔 00≤n≤03〕h
You should select printing position of HRI character when printing Barcode.
* n has the following meaning.
n(hex) Printing position
00 No printing
01 Above barcode
02 Under barcode
03 Above & Under barcode
・ HRI character is printed by font selected with【Font selection of HRI character】.
・ The default of n is [00]h.