Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 46)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 40
27) 【FEED Switch enable/disable】《ESC c 5 n》
Code：〔1B〕h＋〔63〕h＋〔35〕h＋n ※〔 00≤n≤FF〕h
Changes the FEED switch valid or invalid
* “n” is only valid for LSB (b0)
* “n” bit has a following meanings
B0 Description
0 Enable FEED switch
1 Disable FEED switch
* Default value of “n” is [00] h.
28) 【Print and “n” line feed】《ESC d n》
Code：〔1B〕h＋〔64〕h＋n ※〔 00≤n≤FF〕h
Prints the data in the print line buffer and feeds paper by “n” lines.
* The setting value by this command will not remain, so please set the value every time
you use this command.
* Beginning of a line is a next print start position.
* If there is print data remained, line feed should be always activated for th same height
of character.
29) 【Presenter ejection mode set】《ESC h n》
※ This command is effective only when you use Presenter(NPT-301)
Code：〔1B〕h＋〔68〕h＋n ※〔 00≤n≤01〕h
Select “Clamp Feed” or “All Feed” on Presenter Feed mode
*n has a following meanings.
n(hex) Function
00 Clamp Feed
01 All Feed
* Default of n is〔00〕h.
30) 【Full Cut】《ESC i》
Code：〔1B〕h＋〔69〕h
* Full cut the paper is activated.
* Effective at the head of a line
31) 【Partial Cut A】《ESC m》
Code：〔1B〕h＋〔6D〕h
* conduct partial cut (center is left uncut.)
* Effective at the head of a line
32) 【Partial Cut B】《ESC n》
Code：〔1B〕h＋〔6E〕h
* conduct partial cut (a few mm in the center is left uncut.)
* Effective at the head of a line.
* The part of Uncut is thicker than one on (Partial Cut A).