Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 42)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 36
17) 【Back feed】《ESC B n》
Code：〔1B〕h＋〔42〕h＋n ※〔00≤n≤FF〕h
This command is for forwarding paper in reverse direction.
* Set forwarding length in ｎ Dot line. In case of set〔00〕h, no forwarding.
* You should set this command once only due to avoid paper jam, and then forward
paper in right direction.
* Backlash may let paper not put properly.
* In case there is print data on buffer of Print Line buffer, it should be backfeed after
prining.
* Tip of paper should not be exceed the limited of backfeed.
（ Use〔n≤34〕h）
18) 【Horizental tab position set】《ESC D n1 n2 --- NUL》
Code：〔1B〕h＋〔44〕h＋n1＋n2＋---＋〔00〕h ※〔00≤n≤FF〕h
Sets horizental tab position.
* “n” indicates the digits number from the head to the tab position. In this case, [n = tab
position – 1].
* Tab position is set at the location of character width x n from the beginning of a line.
The character width in this case includes character right space. When double width
function is set, then the width becomes double of ordinary character.
* Maximum number of tab positions is 32. If setting exceeds 32, then
the exceeded values are neglected.
* < ESC D NUL > clears all tab positions being set. After the tab is cleared,
(horizontal tab) will be ignored.
* Default value is set at every 8 characters of font A (at 9 th , 17 th , 25 th , 33 rd and 41 st digit).
19) 【Bold print set/reset】《ESC E n》
Code：〔1B〕h＋〔45〕h＋n ※〔 00≤n≤FF〕h
Set and Reset Bold Print
* “n” is only valid for LSB (b0)
* LSB (b0) is defined as following.
b0 Value
0 Resets Bold print
1 Sets Bold print
* When bold print, the result of print may be deformed.
* Default value of n is〔00〕h.
20) 【Double strike print set/reset】《ESC G n》
Code：〔1B〕h＋〔47〕h＋n ※〔 00≤n≤FF〕h
Set and Reset Double Strike Print Function.
* “n” is only valid for LSB (b0)
Control by LSB (b0) is explained as following.
b0 Descriptions
0 Reset Double Strike print
1 Set Double Strike print
* When Double Strike print, the result of print may be deformed.
* Default value of n is 〔00〕h.