Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 27)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 21
4.2 Processing error
1) Error detection details
Name Status
Status
Info
Alarm
Status
Removal
Comm. Error 232C Comm.error - - Adjust comm.condtion
Parity
Overrun
Framing
Normal Normal - OFF
Print start status Print start setting by bit7 1 OFF Print end setting by
command(not error ) command
Paper near empty Remaining paper detect bit0 1 Blink Paper replenishment
Paper near empty sensor
detect
(MS2-4:OFF)
Paper end No paper bit2 1 ON Paper replenishment
Thermal head cover Thermal head cover open bit1 1 ON Thermal head cover
open close
Head Temparature Head Tempt. over 70 °C bit3 1 Blink Automatically recover
at 65 °C
Cuttter error Cutter Paper Jam bit4 1 Blink Open head cover,.
Not connected remove error factor,
Paper detect error Paper not detected during bit5 1 Blink close head cover
presenter operation or Mark
detection.
Presenter clamp Presenter clamps paper bit6 1 Blink Extract paper
When the above errors are detected (except transmission error and paper near empty , print
start status ), printer stops all operation.
・ It turns ON error bit of the status information.
2) Return to normal status from error statuses
Remove causes of error statuses and turn the power on again or push the RESET switch
to return to normal. When this process is activated, at the time of power switch turned off,
the printer will be initialized, so that settings are required again.
If data remains in the buffer, attention should be paid
4.3 Buffer full print
If there remains data after one line of data is received, printer automatically prints preceding
data. The volume of buffer full data varies depending on ANK, Kanji or bit images.