Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 35)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 29
5.2 Printer Driver
Please apply the driver stated below for using under Windows environment.
Windows 2000／Windows XP／Windows CE 5.0／Linux(only sample)
5.3 Command details
1) 【Horizental Tab】《HT》
Code：〔09〕h
Print position is moved at next horizental tab.
* Horizental tab is set by【Horizental tab position set】command.
* Default of【Horizental tab】is every 8
th character（9 digit,17 digit,･･,41digit）in font A.
* If the next【Horizental tab】is not set, this command is disregarded.
2) 【Line feed】《LF》
Code：〔0A〕h
Data in print line buffer is printed, and linefeed is conducted based on preset line feed
quantity.
3) 【Carriage return】《CR》
Code：〔0D〕h
* This command is disregarded.
4) 【Software Reset】《DC1》
Code：〔11〕h
Let Farmware restarted as same procedures when power-on
* Since this command stored on internal reception input buffer executes sequential, the
timing of receptin of command is different from that of command execution.
* Software reset is activated after auto-cutter finished driving.
5) 【Barcode termination change】《ESC RS c n》
Code：〔1B〕h＋〔1E〕h＋〔63〕＋n ※〔 n=00,80〕h
Change terminator of 【Barcode print】command with n.
* n is indicated as follows;
n(hex) termination
00 〔 00〕h
80 〔 FF〕h
* Default of n is〔00〕h
6) 【Setting character right space quantity】《ESC SP n》
Code：〔1B〕h＋〔20〕h＋n ※〔 00≤n≤20〕h
Set the value of right space of character by dot (by 1/203 inch)
* Right space is reflected with zoom when double width zoom mode
* Default of n is〔00〕h.