Rice Lake Star NP-2511 Thermal Kiosk Printer - Manual (Page 36)

D-F0446 NP-2511/3511 series Specifications Ver.0.07 30
7) 【Print mode batch setting】《ESC ! n》
Code：〔1B〕h＋〔21〕h＋n ※〔 00≤n≤FF〕h
Print mode setting
* n has the following meanings.
value
bit funciton
0 1
0 Character font Font A Font B
1 Undifined
2 Undifined
3 Bold reset set
4 Double height reset set
5 Double width reset set
6 Undifined
7 Underline reset set
* If double height and double width are set at the same time, quadruple character will be
formed.
* All of the printed characters will be underlined except for the 90 ° rotated characters and
spaces created by horizontal tab.
* Underline width is determined by the value set in [Underline set/reset] section.
The default value is 1 dot width.
* Bold print control is effected when Kanji mode
* Different sizes of character mixed such as double width and normal size can be
printed.
* The default of n is〔00〕h.
8) 【Absolute position setting】《ESC $ n1 n2》
Code：〔1B〕h＋〔24〕h＋n1＋n2 ※〔 00≤n1≤FF〕h
※〔 00≤n2≤02〕h
Setting from the front on position of start of print by the number of dot
(by 1/203-inch position)
* 256 into the number of dot at print start point is n2、remainder is n1
* print start point is n1＋n2×256 from the front of the line.
* Disregard the setting when beyond the end of the line.
* When this command is received on the middle of line, it is efective not to over the
current position.
9) ■【Download characters set set/reset】《ESC % n》
※ Effective only when Japanese is selected.
Code：〔1B〕h＋〔25〕h＋n ※〔 00≤n≤FF〕h
Set/Reset Download characters
* n is the bottom bit. Effective on only(b0). b0 mentioned as follows;
b0 Function
0 Reset Download character set
1 Set Downlaod character set
* Default of n is 〔00〕h