Navigat ion, Destination input – Mercedes-Benz S-Class 2014 COMAND Manual User Manual

Page 87

Using map

Crosshair

;

Distance of crosshair position from current vehicle position

To switch to navigation mode: press the ß button.

To show the menu: press the controller.

To select

Destination

: turn and press the controller.

Select

Using Map

The map with crosshair is shown.

To move the map: slide XVY, ZVÆ or aVb the controller.

To change the map scale: turn the controller until the desired map scale is selected.

The scale is displayed at the bottom. Turning clockwise zooms out from the map; turning

counter-clockwise zooms in.

To select a destination: press the controller.

If the digital map provides navigable address data, you will see the destination address in

the address entry menu. If not, the

Destination from Map

entry is shown.

If there are multiple destinations around the crosshair, a selection list will appear.

To select a destination from the selection list: turn and press the controller.

To start route calculation: select

Start

Entering way points

Introduction

You can also map the route to the destination

yourself by entering up to four way points. The

sequence of the way points can be changed

at any time.
COMAND provides a selection of predefined

destinations in eight categories for this

purpose, e.g.

GAS STATION

COFFEE SHOP

You can also use the destination entry

options to enter way points.

Destination input

Navigat

ion