Losi LOSB9545 - Manual (Page 5)

Conversion of Brushed Micro Vehicle to Brushless page 5 of 14
Step 5.
Installation of the servo saver
Using the larger Phillips screwdriver remove the white plastic servo horn.
Step 6.
Installation of the servo saver.
First, put the small round piece that is splined on the servo, then the piece with the point.
Slowly screw in the servo saver screw with the spring on it. Be careful to align and screw
it in straight.
Note: Be careful while screwing in this screw to not over-tighten and damage the servo
gears.