Losi LOSB9545 User Manual
Page 14
Conversion of Brushed Micro Vehicle to Brushless
page 14 of 14
Step 15.
Servo Centering:
To check the servo centering make sure your battery is charged. Then turn on the
transmitter and the ESC. To setup the ESC refer to the instructions supplied with it. The
servo should be powered and functioning. Check your transmitter by first turning Right or
Left. Does the steering move in the correct direction for the steering input? If not you
should reverse the servo operation on the transmitter. (See your transmitter instructions.)
1. With the radio and servo still on, and with the transmitter put aside, are the
wheels pointed straight? If not adjust the sub-trim on your transmitter. If by
using the sub trim you can set the wheels to go straight, you can proceed with
Step 16.
2. Note the direction the steering is off to the Right or Left.
3. Adjust the sub-trim back to neutral (zero position) or no sub-trim on transmitter.
4. You will need to turn off the power switch, remove the ESC and servo cover, which
is secured by four (4) screws.
5. Disconnect the servo from the receiver and lift it out of the vehicle.
6. Remembering the direction (Right or Left) the servo was off, carefully remove the
screw holding the servo saver and rotate the servo saver in the direction (right or
left) needed to correct the centering.
Note: you may want to carefully reconnect the servo to the receiver, turn on your
transmitter and ESC to determine if you have moved the servo saver enough.
7. Once you have the servo saver re-centered install the servo back into the vehicle.
Refer to Step 9 above.
8. Install the servo cover with the four (4) screws.
9. Mount the ESC with servo tape. Refer to Step 11 above.
10. The vehicle should be back together now. Turn the transmitter on and then the
ESC. Using the sub-trim adjustment, you should now be able to straighten the
wheels out. If not repeat the above steps beginning at number 4 in this section.
Step 16.
Set-up the ESC:
Follow the instructions supplied with the ESC.
You are now finished with the conversion – congratulations!