Kontron NSW1U IP Network Server - Manual (Page 27)

Kontron IP Network Server NSW1U
December 2009 Product Guide, rev. 1.4
27
Server Installations and Upgrades—NSW1U Network Server
3.2.4 Installing the Front Bezel
1. While holding the front bezel in place, tighten the screws at the left and right edges of the bezel.
3.2.5 Removing the Processor Air Duct
The air duct must be removed to access the processor assembly and the fan assembly. The processor
air duct is required for proper airflow within the chassis. Be sure the air duct is in place before
installing the chassis cover.
1. Power down the server system and unplug all peripheral devices and the power cord.
2. Remove the chassis cover. For instructions, see
Section 3.2.1, “Removing the Chassis Cover” on
page 25 .
3. Remove the screws at the top of the air duct ( Figure 14 , “A”).
4. Lift the air duct from the server platform (“B”).
Figure 13. Removing the Front Bezel
B
A
AF000875