Kontron NSW1U IP Network Server - Manual (Page 19)

Kontron IP Network Server NSW1U
December 2009 Product Guide, rev. 1.4
19
Kontron IP Network Server NSW1U Features—NSW1U Network Server
2.4 NSW1U Network Server Ethernet Ports
The Kontron IP Network Server NSW1U provides for four to twelve (depending on the configuration)
gigabit Ethernet ports to install external NICs. Copper and fiber options are available. For information
on replacing the Ethernet controllers, see Section 5.3, “Replacing the Ethernet Front Panel Board” on
page 68 .
Figure 9. NSW1U Server Control Panel
Item Feature Description
Front Panel Status LEDs
A
Main power LED
(green)
When continuously lit, indicates the presence of DC power in the server. The
LED goes out when the power is turned off or if the power source is
disrupted.
B
System status (green/
amber)
Indicates system status as follows:
• Steady green indicates system in standby or ready for operation.
• Blinking green indicates degraded operation (e.g., power supply non-
redundancy, part of system memory mapped out by BIOS.
• Blinking amber indicates one or more non-critical fault conditions.
• Steady amber indicates one or more critical fault conditions.
C
HDD activity/fault LED
(green/amber/red)
Indicates HDD activity when green, or a HDD fault when amber (non-
critical) or red (critical)
D
NIC activity LED
(green)
Indicates NIC activity
E System ID LED (blue)
Can be toggled remotely or by front-panel ID switch for identification
purposes
Front Panel Switches
F ID switch Toggles system ID LED
G NMI switch Asserts NMI to server board
H Reset switch Resets the system
I Power switch Toggles the system power
AF000818
A B C D E
I H F G