Kontron Micro Client 3 104 - Manual (Page 60)

10. Standard Interfaces – Pin Assignments Micro Client 3 – User’s Guide (Version 1.0)
10.1.3. Serial Port (RS422/RS485) configured as RS422 (4-Channel Mode)
Refer to the chapter 7.3.1 “RS422/RS485 Serial Interface Connector/s”, Table 1, Table 2 and Table 3.
Pin Signal Name 9-pin D-SUB Connector (female)
1 TxD- (Transmit Data-)
2 RxD+ (Receive Data+)
3 TxD+ (Transmit Data+)
4 RxD- (Receive Data-)
5 GND (Signal Ground)
6 RTS- (Request to Send-)
7 RTS+ (Request to Send+)
8 CTS+ (Clear to Send+)
9 CTS- (Clear to Send-)
10.1.4. Serial Port (RS422/RS485) configured as RS485 (4-Wire Mode), full duplex, (Bus-Master)
Refer to the chapter 7.3.1 “RS422/RS485 Serial Interface Connector/s”, Table 1, Table 2 and Table 3.
Pin Signal Name 9-pin D-SUB Connector (female)
1 TxD- (Transmit Data-)
2 RxD (Receive Data+)
3 TxD+ (Transmit Data+)
4 RxD- (Receive Data-)
5 GND (Signal Ground)
6 NC
7 NC
8 NC
9 NC
58 www.kontron.com