Kontron Micro Client 3 104 - Manual (Page 41)

7. Product Description Micro Client 3 – User’s Guide (Version 1.0)
5. By use of an insulated thin tool (e. g. screwdriver or a stylus) set the DIP switches to the up (for ON) or down (for OFF)
position corresponding the needed port configuration (refer to the Table 1, Table 2 and Table 3).
Fig. 41: DIP1-DIP8 switches (shown with factorry settings)
6. Replace carefully the cover to the system and screw it on with the retained screws.
7.
Tighten the retained screws when the cover is firmly in place.
DIP Switches (DIP1-DIP8)
www.kontron.com 39