Kontron AM5010 BIOS - Manual (Page 29)

AM4010/AM4011/AM5010 BIOS Advanced Setup
ID 1022-2060, Rev. 2.0 Page 19
Third IDE Slave
This function provides access to the Third IDE Slave sub-screen. To access the Third IDE
Slave screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Fourth IDE Master
This function provides access to the Fourth IDE Master sub-screen. To access the Fourth IDE
Master screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Fourth IDE Slave
This function provides access to the Fourth IDE Slave sub-screen. To access the Fourth IDE
Slave screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Hard Disk Drive Write Protect
This function is to used to specify write protection for all hard disk drives in the system.
Optimal and Fail-Safe default settings: Disabled
IDE Detect Time Out (Sec)
Optimal and Fail-Safe default settings: 35
SETTING DESCRIPTION
Disabled Use this setting to disable the hard disk drive write protect.
Read, write, and erase functions can be performed on all of the hard disk drives.
Enabled Use this setting to prevent all of the hard disk drives from being erased.
SETTING DESCRIPTION
0, 5, 10, 15, 20, 25,
30, 35
(in seconds) Use one of these settings to specify how long the BIOS is to wait for IDE devices to be
detected before continuing with booting.
Basically, this enables fine-tuning of the settings to allow for faster boot times. Adjust this
setting until a suitable timing that can detect all attached IDE disk drives is found.