Kontron AM5010 BIOS - Manual (Page 28)

Advanced Setup AM4010/AM4011/AM5010 BIOS
Page 18 ID 1022-2060, Rev. 2.0
Configure SATA as
This function controls the SATA controller device's operating mode and is only available if the
ATA/IDE Configuration is set to Enhanced.
Optimal and Fail-Safe default settings when ATA/IDE Configuration is set to Enhanced: IDE
Primary IDE Master
This function provides access to the Primary IDE Master sub-screen. To access the Primary
IDE Master screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Primary IDE Slave
This function provides access to the Primary IDE Slave sub-screen. To access the Primary IDE
Slave screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Secondary IDE Master
This function provides access to the Secondary IDE Master sub-screen. To access the Sec-
ondary IDE Master screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Secondary IDE Slave
This function provides access to the Secondary IDE Slave sub-screen. To access the Second-
ary IDE Slave screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
Third IDE Master
This function provides access to the Third IDE Master sub-screen. To access the Third IDE
Master screen, select this function and press .
Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.
SETTING DESCRIPTION
IDE Use this setting to specify that the SATA controller is to operate as a legacy IDE controller.
In this case, old IDE drivers may be used.
AHCI Use this setting to specify that the SATA controller is to operate as an AHCI controller.
In this case, AHCI drivers must be used.