EFCO 904 Series - Manual (Page 47)

3
3a
set on the setting block.
(2) Tip the glass to vertical.
(3) Install the face cover.
(1) Tip the glass back to
GLASS BITE
1/2"
SILL
1
3
SNAP ON HORIZONTAL
FACE AFTER ALL LITES
GLASS ABOVE HORIZONTAL
MUST BE OUTSIDE GLAZED.
ARE SET.
NOTE:
2
2
1
GLASS BITE
1/2"
HEAD
STEP 1)
(3a) Set the glass on the
setting blocks.
[FIG. 54]
DPS 12/2002
(3) Set the glass on the setting blocks.
(1a) Hold the glass vertical.
glass plane.
(2a) Rotate the glass to the
1a
2a
as described for the top lite,
The glass unit may also be set
-OPTIONAL AT LOWER LITE-
except from the inside.
HORIZONTAL
(2) Raise the glass to clear the
glazing pocket.
(1) Tip the glass into the head
setting blocks.
PAGE 45
SECTION V B - GLAZING PROCEDURES
FOR BUTT GLAZED VERTICAL AND INTERMEDIATE HORIZONTAL
Quick Set
WHEN A HORIZONTAL INTERMEDIATE IS BEING USED,
GLASS SETTING OPTIONS INCLUDE INSIDE/OUTSIDE
GLAZING OPPORTUNITIES. THE GLASS ABOVE THE
HORIZONTAL WILL BE SET FROM THE OUTSIDE, AND
THE GLASS BELOW MAY BE SET FROM THE OUTSIDE
OR THE INSIDE. SEE FIG. 54 BELOW.