EFCO 904 Series - Manual (Page 24)

CAPTURED VERTICALS
5/8" NOTCH AT
2 PC. JAMBS ONLY
1" NOTCH AT
8583
.542
DPS 7/2001
NOTCH
SECTION III G - FABRICATION
HORIZONTAL CUT LENGTH FORMULAS
CUT LENGTH = EXTERIOR D.L.O. {at BUTT GLAZED MULLION to
CUT LENGTH = EXTERIOR D.L.O. + 1 1/4" {at CAPTURED VERTICAL MULLION to
CUT LENGTH = EXTERIOR D.L.O. + 1 5/8" {at 2 pc. JAMB to
CUT LENGTH = EXTERIOR D.L.O. + 1" {at 2 pc. JAMB to BUTT GLAZED MULLION
NOTCH
5/8" x 7/32" NOTCH IS REQUIRED AT CAPTURED VERTICALS ONLY.
1" x 7/32" NOTCH IS REQUIRED AT 2 PC. JAMBS ONLY.
5/8" LONG
**
1" LONG
CAPTURED VERTICAL MULLION
PLEASE REFERENCE PAGE 35 FIG. 36.
[Fig. 14]
#10-24x
AT VERTICALS
9469 SIMILAR
8583 SHOWN
.344 (11/32") DRILL
BOTH ENDS
AT JAMB
1/2" F.H.
(S110)
CAPTURED VERTICAL MULLION
BUTT GLAZED MULLION
[Fig. 15]
INTERMEDIATE HORIZONTAL
PAGE 22
THE FOLLOWING PREPS APPLY TO 902 AND 901 ONLY.
SYSTEMS 903 AND 904 HAVE A ’SNAP FIT’ TO THE SHEAR
BLOCK AND DO NOT REQUIRE DRILL/SCREW ATTACHMENT
OR NOTCHING.
7/32" 1"