Salter Brecknell 800 Series - Manual (Page 36)

CHAPTER 8: LEGAL FOR TRADE SEALING
8.1 ABS ENCLOSURE
The 800/800S indicator in the ABS enclosure can be sealed for commercial (Legal for
Trade) applications as follows.
1. Power off the indicator by unplugging the power source.
2. On the back of the indicator, locate the Setup/Calibration Slide Switch Cover Plate (see
illustration below).
3. Thread a wire security seal through both drilled head screws securing the calibration
switch cover.
DC Jack Serial Port Connector
LOAD CELL
Setup/Calibration Switch
Figure 8-1: 800/800S ABS Rear Panel
Older units
1. Power off the indicator.
2. Locate the two adjacent drilled head screws securing the rear cover.
3. Thread a wire security seal through two drilled head screws securing the rear cover.