Salter Brecknell 800 Series - Manual (Page 14)

3.2.3 NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 3-1 to move around in the Setup Menu
Chart shown in Figure 3-2 on the following page.
1.
To move to a new “F” heading, use the 4 (left) or 5 (right) key to move right or
left in the Setup Menu Chart.
2. To move to the selection level, press the 2 (down) key once. The current
saved selection is shown.
3. To view the available selections for the current “F” heading, use the 4 (left) or
5 (right) key to move through the selection field.
4. To save a new selection, press the NET/GROSS (Set) key .To exit without
saving, press the 1 (up) key to return to the current “F” heading.
5. Repeat Steps 1 through 4 until the Setup Menu is programmed.
SETUP MENU MODE KEY FUNCTIONS
2
GROSS
NET 4 5
SET
1
Figure 3-1: Setup Menu Key Assignments
F1
Grads
F2
Span Gn.
F4
Zero Range
F5
Mot. Band
F6
Dig. Filter
F7
Ovld. Limit
25 50 75 100 150 200 1 2 4 8 100% 1.9%
1d 3d 5d 10d
F8
Calib. Unit
F9
Dsp. Div.
lb kg
500 1000 1500 2000 2500 3000 4000 5000 6000 8000 10000 12000 20000 30000 40000 50000
0.5d 1d 3d 0d 5d
F3
Zero Band
0d 2% 1d 9d
1 2 5
F10
Dec. Pt.
F17
Span Calib.
Press #2
key to begin
F18
Cal. View
Press #2
key to begin
F19
Key-in Zero
Press #2
key to begin
F20
Key-in Span
Press #2
key to begin
0 0.0 0.00 0.000 0.0000 00
F16
Zero Calib.
Press #2
key to begin
Auto 12 16 32 64
F11
CU Mult.
Press #2
key to begin
F12
CU Enable
0 1
F13
PC Enable
0 1
F14
lb/kg Enable
0 1
Figure 3-2: Setup Menu Chart