Salter Brecknell 800 Series - Manual (Page 15)

3.2.4 NOTES ON THE SETUP MENU
1. There is an F21 sub-menu present that is for FACTORY USE ONLY!
2. Detailed descriptions of the setup menu parameters can be found in Chapter 4 of
this manual.
3. The User (“A”) menu sub-menus appear when scrolling left or right from the
“F” menu.
3.2.5 EXITING THE SETUP MENU – ABS ENCLOSURE
1. Power off the indicator by unplugging the power source.
2. On the back cover, move the Setup/Calibration Switch back to its original
position.
3. Power on the indicator by plugging in the power source. The display will go
through a digit check, then settle into Normal Operating mode. All front panel keys
will now return to their normal mode of operation.
3.2.6 EXITING THE SETUP MENU – STAINLESS STEEL ENCLOSURE
1. Power off the indicator.
2. Move the slide switch on the rear cover back to the left.
3. Power on the indicator. The display will go through a digit check, then settles into
Normal Operating mode. All front panel keys will now return to their normal mode of
operation.