Salter Brecknell 800 Series - Manual (Page 13)

CHAPTER 3: CONFIGURATION
3.1 CONFIGURATION OVERVIEW
The indicator contains two main setup menus: The Setup (“F”) menu which configures the
indicator to your weigh platform and the User (“A”) menu which configures the serial
communication port and enables some user options. The Setup and User menus consist of
several menu selections, each with its own sub-menu of choices.
To set up the indicator, you must first enter the appropriate menu mode. Once there, four of the front
panel keys become directional navigators to move around in the menus, and one key is used to save
or SET the selections.
3.2 SETUP (“F”) MENU
3.2.1 ENTERING THE SETUP MENU – ABS ENCLOSURE
4. Power off the indicator by unplugging the power source.
5. On the back cover, move the Setup/Calibration Switch to the opposite position.
6. Power on the indicator by plugging in the power source. The indicator shows ” F
1” to indicate that you are in Setup Menu mode.
Note: Access to the Setup/Calibration Switch is inhibited if the indicator has been
sealed for commercial use. For more information, please refer to Chapter 8.
3.2.2 ENTERING THE SETUP MENU – STAINLESS STEEL ENCLOSURE
1. Power off the indicator.
2. Locate the slide switch on the rear cover and move it to the right.
NOTE: A metal plate held on by two drilled-head screws may conceal the slide
switch.
3. Power on the indicator. The indicator shows ” F 1” to indicate that you are in
Setup Menu mode.
Note 1: Access to the back cover is inhibited if the indicator has been sealed for
commercial use. For more information, please refer to Chapter 8.
1. Power on the indicator. The indicator shows ” F 1” to indicate that you are
in Setup Menu mode.