Salter Brecknell 800 Series - Manual (Page 16)

3.3 USER (“A”) MENU
3.3.1 ENTERING THE USER MENU
1. Enter the Setup (“F”) menu by following the directions in Section 3.2.1 or 3.2.2.
2. Use the right or left directional keys shown in Figure 3-3 to move right or left in
the Setup (“F”) menu until the indicator shows ” A 1”.
3.3.2 NAVIGATING IN THE USER MENU
Use the directional keys shown in Figure 3-3 to move around in the User Menu
Chart shown in Figure 3-4 on the following page.
1.
To move to a new “A” heading, use the 4 (left) or 5 (right) key to move right or
left in the User Menu Chart.
2. To move to the selection level, press the 2 (down) key once. The current
saved selection is shown.
3. To view the available selections for the current “A” heading, use the 4 (left) or
5 (right) key to move through the selection field.
4. To save a new selection, press the NET/GROSS (Set) key .To exit without
saving, press the 1 (up) key to return to the current “A” heading.
5. Repeat Steps 2 through 5 until the User Menu is programmed.
USER MENU MODE KEY FUNCTIONS
2
GROSS
NET 4 5
SET
1
Figure 3-3: User Menu Key Assignments