Charging the battery pack, Connect the power cord, Remove the cover – Canon EOS D30 User Manual
Page 25: Place the battery in the adapter, Charge the battery pack
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging the Battery Pack
Connect the power cord.
Connect the power cord to the compact
power adapter.
€i Insert the plug into a power outlet.
Remove the cover.
Store the cover in a place where It will not
be lost.
® If you remove the battery from the camera,
be sure to reattach the cover to protect
against shorting.
Place the battery in the adapter.
Align the end of the battery with the (-) mark
on the adapter, press down on the battery,
and slide it into place.
* lb remove the battery, use the reverse of
the above.
Batteries can be charged in either the left
or right side of the adapter.
CD
0
o’
cB
g:
c
CD
0
o'
Battery charge
Charge lamp
0-50%
Blinks once per
second
50-75%
Blinks twice per
second
Over 75%
Blinks three times
per second
100%
Stays on
Charge the battery pack.
® As soon as you place the battery pack in
the compact power adapter, the charge
lamp starts blinking and charging begins.
# When charging is complete, the lamp
stops blinking and stays on.
It can take up to 90 minutes to fully
charge a battery pack.
You can check whether a battery is
charged by seeing whether the charge
lamp blinks or stays on.
When charging is complete, the charge
lamp stops blinking and stays on. You can
continue
charging
the
battery
for
approximately an hour to reach full charge
capacity.
When charging is complete, remove the
battery and unplug the power cord from
the outlet.
25