Attaching and removing lens cap and lens hood, Adjusting grip beit, Attaching strap – Canon E800 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching and Removing Lens Cap and Lens Hood
Remove lens cap before recording and hook it onto grip belt using clip on
lens cap. Replace lens cap again when you stop recording or turn the
camera off.
When using a filter, attach the lens hood (as pictured below), so lens cap
can be replaced.
• To remove the lens hood, hold focusing ring and filter with one hand and
loosen the lens hood using the flat palm of your other hand (not your
fingers).
Adjusting Grip Beit
Tighten or loosen grip belt as necessary for a comfortable fit while holding
grip with your right hand.
Attaching Strap
Attach shoulder strap to the strap attachment bars, and adjust it to the most
comfortable length.
The optional wrist strap can only be attached to the lower strap attachment
bar.
Camera Preparations 19