Power sources, Bp-e77k battery pack, Attaching battery pack – Canon E800 User Manual

Page 23: Slide battery pack into power source compartment, Press until it clicks and locks in place, Removing battery pack, Slide and hold ватт eject switch up, Pull battery pack out as shown

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Power Sources

BP-E77K Battery Pack

Make sure battery pack is fully charged before use.
Continuous recording time is approximately 40 minutes.

• Some camera modes consume more power than others, so actual recording

time may be less than 40 minutes.

• The safest policy is to have enough batteries to cover two to three times

the length of recording time scheduled.

• Using battery pack in cold temperature will shorten recording time.
• Battery pack normally becomes warm during use.
• Battery’s + and - terminals may short circuit if they come in contact

with any metal objects. Take care when handling battery pack, and keep it

in plastic or other protective covering when carrying or storing.

• Power is slowly drained while the battery pack is attached to the camera,

even when the camera is turned off. Remove the battery pack when you
don’t expect to use the camera for a long time.

• See battery pack instruction manual for further information regarding

battery pack.

• Use the optional BP-E722 Battery Pack for lengthy recording (see p.60).

BP-E722 (Option)

Attaching Battery Pack

Slide battery pack Into power source compartment.

• Insert the end marked with a triangle.
• Slightly loosen grip belt and press it down for easy battery loading.

Press until it clicks and locks In place.

Removing Battery Pack

ВАТТ EJECT

Slide and hold ВАТТ EJECT switch up.

Pull battery pack out as shown.

• Do not remove battery pack during camera operation.

Before Using Your Camera