Canon E800 - Manual (Page 26)

Inserting New Lithium Battery
The CR2025 type lithium battery provides your camera with enough power
to store character and digital titles, date and time settings, even when the
camera is turned off.
One lithium battery will last approximately one year. When lithium battery
is not in place or is nearly exhausted, “DATE” flashes in viewfinder,
indicating that the lithium battery needs to be replaced.
Be sure to connect the camera to a power source before changing the
lithium battery, otherwise character and digital titles, date and time settings
will be cleared from camera’s memory and will have to be reset.
Open the lithium battery compartment cover located at the
bottom of the camera.
Insert the lithium battery with the ( + ) side up.
• Insert the lower section first, then push into place.
• Make sure the battery is secured in place under the hooks.
Close the cover.
• Make sure cover fastens properly (snaps into place).
Warning:
The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge,
disassemble, heat above 100°C or incinerate. Replace battery with Panasonic CR2025 or Duraceli DL2025B.
Use of another battery may present a risk of fire or explosion. The used battery should be handed back to the
supplier.
Caution;
• Make sure plus ( + ) side is facing up in battery compartment.
• Keep battery out of children’s reach. If swallowed, contact physician immediately.
• To ensure proper contact, wipe battery with clean, dry cloth before use.
• Do not pick up battery using tweezers or other metal tools which may cause short circuiting.
• Do not disassemble, heat or immerse in water, to avoid risk of explosion.
Power Sources
13