Compaq Deskpro 2000 - Manual (Page 125)

Compaq Deskpro 2000 Series of Personal Computers 5-25
5.14.3 Bezel Blank
To remove a bezel blank, complete the following steps:
1. Remove the system unit cover (Section 5.6).
2. Remove the front bezel (Section 5.14.1).
3. Lay the front bezel face down on a protected work surface. Push the tab that is on the right of the
bezel blank to the right.
4. Rotate the bezel blank up and out of the front bezel.
Figure 5-23. Removing the Bezel Blank
To reinstall the bezel blank, reverse the above procedure.