When to replace the battery pack, Cuándo reponer el paquete de baterías, Notes on the rechargeable battery pack – Sony CCD-SC55 User Manual
Page 75: Caution, The battery pack heats up, Notas sobre el paquete de baterías recargable, Precaución, El paquete de baterías se calienta
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

When to replace the battery
pack
While you are using your camcorder, the
remaining battery indicator on the LCD screen
decreases gradually as battery power is used up
[a]-
When using the InfoLITHIUM battery pack such
as the NP-F530, the remaining time in minutes
appears.
Cuándo reponer el paquete de
baterías
Mientras se usa la videocámara, el indicador de
batería restante de la pantalla LCD disminuye
gradualmente a medida que se agota la potencia
de la batería
[a]
Cuando se utiliza el paquete de baterías
InfoLITHIUM, como NP-F530, aparece el tiempo
restante en minutos.
■'•i
[a]
When the remaining battery indicator reaches the
lowest point,the iX: indicator appears and starts
flashing on the LCD screen.
When the PC indicator on the LCD screen
changes from slow flashing to rapid flashing
while you are recording, set the POWER switch
to OFF on the camcorder and replace the battery
pack. Leave the tape in the camcorder to obtain a
smooth transition between scenes after the
battery pack has been replaced.
When you use the InfoLITHIUM battery pack,
depending on conditions, the PC indicator may
flash, even if there are 5 to 10 minutes remaining.
Notes on the rechargeable
battery pack
Caution
Never leave the battery pack in temperatures
above 140°F (60°C), such as in a car parked in the
sun or under direct sunlight.
The battery pack heats up
During charging or recording, the battery pack
heats up. This is caused by energy that has been
generated and a chemical change that has
occurred inside the battery pack. This is not
cause for concern, and is normal.
Cuando el indicador de batería restante llega al
punto más bajo, aparece el indicador PO en la
pantalla LCD y empieza a parpadear.
Cuando el indicador Pd de la pantalla LCD pase
de un parpadeo lento a uno rápido mientras
graba, ajuste el interruptor POWER de la
videocámara en OFF y sustituya el paquete de
baterías. Deje la cinta en la videocámara para que
la transición entre las escenas sea uniforme
después de sustituir el paquete de baterías.
Cuando se utiliza el paquete de baterías
InfoLITHIUM, el indicador td puede
parpadear, dependiendo de las condiciones,
incluso si el tiempo restante es de 5 a
10 minutos.
Notas sobre el paquete de
baterías recargable
Precaución
No deje nunca el paquete de baterías a
temperaturas superiores a 140°F (60“C), como el
interior de un automóvil aparcado al sol o bajo la
luz solar directa.
El paquete de baterías se calienta
Durante la carga o la grabación, el paquete de
baterías se calienta. Esto se debe a la energía
generada y a un cambio químico producido
dentro del paquete de baterías. No es motivo de
preocupación y es normal.
75