Canon BJC-3000 - Manual (Page 121)

121 Using the Scanner
Using the Scanning Holder
Load the image you wish to scan in the scanning holder. Be careful that
you place the image in the defining point correctly as shown in the figure.
(The defining point is set 3.4mm away from the left margin and 6mm away
from the top margin.)
Scanning results may be blurred or distorted within the area of 32mm away
from the top margin and 21mm away from the bottom margin of the scan-
ning holder.
3.4mm
6mm
Defining
point
Scanning holder
Scanning area (width)
Scanning area (height)
Note