Rally Armor 2013+ Subaru Crosstrek XV - Manual (Page 2)

IMF 26
Version 1.0 Release Date 03.16.2013
2
Front Mud Flap Installation
Begin by parking the vehicle on an even surface. Turn the steering wheel to allow access to the inner wheel well area.
• (Figure A) Remove front fender liner fastener located underneath the side skirt.
• (Figure B) Remove the three OEM fender liner fasteners (as shown). Carefully unclip front portion of side skirt by pulling the front
outer edge away just enough to release first two horizontal retainer clips. Pull liner away to gain access to the interior fender area.
• (Figure C) Place 3 polygon clips over mounting tabs at an angle (as shown). Re-install liner, do not re-install side skirt clips
• (Figure D) Using a wrench, remove the 10mm bolt hidden behind side skirt area.
• (Figure E) Mount square edge of front using the 10mm bolt, tighten until snug but adjustable. Round edge faces engine side. Place
polygon clip over round edge.
• (Figure F) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender
liner and bracket. Place a washer (SmWash) over a long screw (1.5SS) of the original screws through the flap into the mounted clips
shown in image as “A”,”B”,”C”,”D”. Important - On the top most mount “A” place a spacer (.25SP) behind the mud flap.
Reinstall side skirt back into place. Align outer edge of the flap by incrementally adjusting the angle of the flap and walking away
from the vehicle until the flap is perpendicular to even ground. Tighten all mounting screws and bracket bolt only until snug.
Do not over tighten
•