Dell PowerEdge T710 - Manual (Page 74)

74
Using the System Setup Program and UEFI Boot Manager
To disable the password security:
1 Turn on or reboot your system by pressing .
2 Type your password and press .
When Password Status is Locked, you must type the password and press
when prompted at reboot.
If an incorrect system password is entered, the system displays a message and
prompts you to re-enter your password. You have three attempts to enter the
correct password. After the third unsuccessful attempt, the system displays an
error message that the system has halted and will shut down.
Even after you shut down and restart the system, the error message continues
to be displayed until the correct password is entered.
NOTE:
You can use the Password Status option in conjunction with the System
Password and Setup Password options to protect your system from unauthorized
changes.
Deleting or Changing an Existing System Password
1 Press at the password prompt to disable the existing
system password.
If you are asked to enter your setup password, contact your network
administrator.
2 Enter the System Setup program by pressing during POST.
3 Select the System Security screen to verify that the Password Status is
Unlocked.
4 Type the system password.
5 Confirm that Not Enabled is displayed for the System Password.
If Not Enabled is displayed for the System Password, the system password
has been deleted. If Enabled is displayed for the System Password, press
the key combination to restart the system, and repeat step 1
to step 5.
book.book Page 74 Monday, June 15, 2009 11:33 AM