Dell PowerEdge T710 - Manual (Page 50)

50
About Your System
The following
DIMMs should
match in
geometry:
x,x,...
Invalid memory
configuration. The specified
memory modules do not
match in size, number of
ranks, or number of data
lanes. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98.
The following
DIMMs should
match in rank
count: x,x,...
The following
DIMMs should
match in size:
x,x,...
The following
DIMMs should
match in size
and geometry:
x,x,...
The following
DIMMs should
match in size
and rank count:
x,x,...
Thermal sensor
not detected on x
A memory module without a
thermal sensor is installed in
the specified memory slot. Replace the memory
module. See "System
Memory" on page 98.
Time-of-day
clock stopped
Faulty battery or faulty chip. See "Troubleshooting the
System Battery" on page 165.
Time-of-day not
set - please run
SETUP program
Incorrect Time or Date
settings; faulty system
battery. Check the Time and Date
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 57. If the problem
persists, replace the system
battery. See "System Battery"
on page 144.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 50 Monday, June 15, 2009 11:33 AM