Dell PowerEdge T710 - Manual (Page 46)

46
About Your System
Memory set to
minimum
frequency.
The memory frequency may
be intentionally set lower for
power conservation. If not an intentional setting,
check any other system
messages for possible causes.
The current memory
configuration may support
only the minimum frequency. Ensure that your memory
configuration supports the
higher frequency. See
"General Memory Module
Installation Guidelines" on
page 98.
Memory tests
terminated by
keystroke.
POST memory test was
terminated by pressing the
spacebar. Information only.
MEMTEST lane
failure detected
on x
Invalid memory
configuration. Mismatched
memory modules are
installed. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98.
Mirror mode
disabled. For
mirror mode,
DIMMs must be
installed in
pairs. Pairs must
be matched in
size and
geometry.
The memory configuration
does not match the setting in
BIOS. The BIOS setting has
been disabled. Reconfigure the memory
modules for Memory
Mirroring mode. See
"System Memory" on
page 98.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 46 Monday, June 15, 2009 11:33 AM