Dell PowerEdge T710 - Manual (Page 41)

About Your System
41
Alert! Power
required exceeds
PSU wattage.
Check PSU and
system
configuration.
Alert!
Continuing
system boot
accepts the risk
that system may
power down
without warning.
The system configuration of
processor(s), memory
modules, and expansion
cards may not be supported
by the power supplies. If any system components
were just upgraded, return
the system to the previous
configuration. If the system
boots without this warning,
then the replaced
component(s) are not
supported with this power
supply. If Energy Smart
power supplies are installed,
replace them with High
Output power supplies to
use the components. See
"Internal SD Module" on
page 119.
Alert! Redundant
memory disabled!
Memory
configuration
does not support
redundant
memory.
Memory Sparing or Memory
Mirroring was enabled in the
system setup program, but
the current configuration
does not support redundant
memory. A memory module
may be faulty. Check the memory modules
for failure. See
"Troubleshooting System
Memory" on page 167. Reset
the memory setting, if
appropriate. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 57.
Alert! System
fatal error
during previous
boot.
An error caused the system to
reboot. Check other system
messages for additional
information for possible
causes.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 41 Monday, June 15, 2009 11:33 AM