Dell PowerEdge T710 - Manual (Page 44)

44
About Your System
DIMM
configuration on
each CPU should
match.
Invalid memory
configuration on a dual-
processor system. The
memory module
configuration for each
processor must be identical. Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98.
Embedded NIC x and
NIC y:
OS NIC=
|DISABLED>,
Management
Shared NIC=
|DISABLED>
The OS NIC interface is set
in BIOS. The Management
Shared NIC interface is set in
management tools. Check the system
management software or the
System Setup program for
NIC settings. See
"Troubleshooting a NIC" on
page 161.
Error 8602 -
Auxiliary Device
Failure. Verify
that mouse and
keyboard are
securely
attached to
correct
connectors.
Mouse or keyboard cable is
loose or improperly
connected. Reseat the mouse or
keyboard cable.
Defective mouse or keyboard. Ensure that the mouse or
keyboard is operational. See
"Troubleshooting a USB
Device" on page 160.
Gate A20 failure Faulty keyboard controller;
faulty system board. See "Getting Help" on
page 193.
Invalid
configuration
information -
please run SETUP
program.
An invalid system
configuration caused a
system halt. Run the System Setup
program and review the
current settings. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 57.
Invalid PCIe card
found in the
Internal_Storage
slot!
The system halted because
an invalid PCIe expansion
card is installed in the
dedicated storage controller
slot. Remove the PCIe expansion
card and install the
integrated storage controller
in the dedicated slot.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 44 Monday, June 15, 2009 11:33 AM