Dell PowerEdge T710 - Manual (Page 108)

108
Installing System Components
8 Gently lift the heat sink off of the processor and set the heat sink aside
upside down (thermal grease side facing up).
Figure 3-12. Installing and Removing the Heat Sink
CAUTION:
The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
9 Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position by pushing down and pulling out
from under the tab. Rotate the lever 90 degrees upward until the processor
is released from the socket. See Figure 3-13.
10 Use the tab on the processor shield to rotate shield upward and out of the
way. See Figure 3-13.
1 heat sink 2 release lever (2)
1
2
book.book Page 108 Monday, June 15, 2009 11:33 AM