Dell PowerEdge T710 - Manual (Page 42)

42
About Your System
BIOS
MANUFACTURING
MODE detected.
MANUFACTURING
MODE will be
cleared before
the next boot.
System reboot
required for
normal
operation.
System is in manufacturing
mode. Reboot to take the system
out of manufacturing mode.
BIOS Update
Attempt Failed!
Remote BIOS update
attempt failed. Retry the BIOS update. If
problem persists, see
"Getting Help" on page 193.
Caution!
NVRAM_CLR jumper
is installed on
system board.
Please run SETUP
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared. Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5). See
Figure 6-1 for jumper
location. Restart the system
and re-enter the BIOS
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 57.
CPU set to
minimum
frequency.
The processor speed may be
intentionally set lower for
power conservation. If not an intentional setting,
check any other system
messages for possible causes.
CPU x installed
with no memory.
Memory modules are
required but not installed in
the indicated processor’s
memory slots. Install memory modules for
the processor. See "System
Memory" on page 98.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 42 Monday, June 15, 2009 11:33 AM