Dell PowerEdge M600 - Manual (Page 92)

92
Using the System Setup Program
To leave the password security enabled:
1 Turn on or reboot your system by pressing .
2 Press .
3 Type your password and press .
To disable the password security:
1 Turn on or reboot your system by pressing .
2 Press .
When the Password Status option is set to Locked whenever you turn on your
system or reboot your system by pressing , type your
password and press at the prompt.
After you type the correct system password and press , your system
operates as usual.
If an incorrect system password is entered, the system displays a message and
prompts you to re-enter your password. You have three attempts to enter the
correct password. After the third unsuccessful attempt, the system displays an
error message showing the number of unsuccessful attempts and that the
system has halted and will shut down. This message can alert you to an
unauthorized person attempting to use your system.
Even after you shut down and restart the system, the error message continues
to be displayed until the correct password is entered.
NOTE:
You can use the Password Status option in conjunction with the System
Password and Setup Password options to further protect your system from
unauthorized changes.
Deleting or Changing an Existing System Password
1 When prompted, press to disable the existing system
password.
If you are asked to enter your setup password, contact your network
administrator.
2 Enter the System Setup program by pressing during POST.
3 Select the System Security screen field to verify that the Password Status
option is set to Unlocked.
4 When prompted, type the system password.