Dell PowerEdge M600 - Manual (Page 118)

118
Installing Blade Components
Memory Sparing Support - PowerEdge M605
Memory sparing is supported in single- or dual-processor systems that have one
of the fully populated memory configurations shown in Table 3-9. The memory
sparing feature must be enabled in the Memory Information screen of the
System Setup program. See "Memory Information Screen" on page 83. To use
memory sparing, you must disable node interleaving.
Memory sparing allocates only the first rank of memory of a DIMM. For a
single-rank DIMM, the entire capacity of the DIMM must be allocated for
sparing along with the adjacent single-rank DIMM to spare a memory
channel. For dual-rank DIMMs, two DIMMs are also required for sparing, but
as only the first rank of each DIMM is allocated, only half of a dual-rank
DIMM’s capacity is allocated for sparing. The second ranks on both DIMMs
are available memory. Table 3-9 shows how memory sparing splits the
available and spared memory in each memory module configuration.